Features
- Memory programmer for high-speed memory, flash memory and emmc programming
- Optional upgrade pack for support of PLD, CPLD and FPGA
- 112 powerful universal pin drivers
- USB 2.0 port for high-speed data download
- Built-in 8 Gbit RAM buffer expandable to 16 Gbit
- Multi-linkable for gang programming with pipelined throughput
- Software with task management and password protection for Windows 7/10
- Real-time graphic statistics management
- On-line automatic failure analysis
- Configuration of programming parameters for fine-tuning
- 2-, 4- and 8-socket-boards for e.g. flash devices available
- Serialisation also possible with multi-socket-boards
- Supports all available socket boards types OT, CS, ZIP, HIC, S4, S8 (emmc) and T4 depending upon configuration
This device is the perfect solution for your wireless network applications based on the IEEE 802.11g standard that offers a data rate up to 54Mbps in a wireless LAN environment. It is a high-speed wireless network card that plugs into your system and accesses to the LAN or peer-to-peer networking easily without wires or cables. GMC-I Messtechnik GmbH 3 1 Ribbon cable with RS232 plug for connection of the SI module to the tester 2 USB socket connector for the transmission of stored data to the PC 3 LED signal lights up green when USB interface is active provided the USB device driver has been installed to the connected PC. Install the USB driver. The oscilloscope is a USBTMC device. If your PC has installed EasyScope software and NI software, the first time the oscilloscope and PC are connected correctly and turned on, the PC Hardware Update Wizard dialog box will pop up. Follow the prompts of the installation wizard “USB Test and Measurement Device” driver.
The T9200+ device programmer is the ideal system for users who want to program EPROM, EEPROM, FLASH, NAND- and NOR-Flash, SPI Flash, emmc and microcontrollers. Logic devices such als PLD, CPLD and FPGA are not supported by standard, but can be included also later as an option. T9200+ by standard offers 112 universal pin drivers and an integrated RAM buffer. Programming capacities can easily be extended by adding further programmers via USB connection and USB hub with 4 slots.
Comprehensive user software:
The PUI software contains task management software to create pre-defined programming jobs (tasks), task version control and password protection (administrator and operator mode). The software offers any possibilities and information to configure and save tasks including serialization and comprehensive statistics administration. Created tasks can be used in APxxx automated systems, as well as in manual models T9x00(+).
S4 socket boards enhance programming throughput by 4 times:
The 4-site S4 socket boards allow to program 4 devices at a time and thus significantly increase throughput. Also serial numbering is possible for up to 4 devices each with its own serial number. For NAND flash devices, its isolated circuitries for each socket enable independent Bad Block management for each device, which ensures the highest yields as well as the highest programming reliability.
Maximum flexibility and cost savings using the new T4 socket boards:
T4 socket boards’ new architecture increases the programming speed considerably and can raise throughput by up to 5x; considering the ever growing memory sizes of MCUs, this can bring a considerable advantage. With their flexible design they can be used with 1, 2, 3 or 4 sockets, which allows for maximum flexibility in throughput and lowest cost possible – from prototyping to mass production. Also serial numbering is possible for up to 4 devices each with its own serial number.
Gmc-i Messtechnik Usb Devices Driver Download For Windows 10
Driver Downloader
And as with any System General equipment, you receive maximum flexibility at minimum cost:
Most current programming algorithms are provided free of charge for download about every six weeks. Sockets with receptacles are not proprietary. New algorithm development is free of charge. True universal programmers. Socket boards can be used on manual programmers as well as on automated APxxx programming systems.